Your progress
Ticks are kept only in this browser: clearing your browsing data or changing device loses them. · ·

June 2019 Paper 3 Q15

OCR MEICurrent spec3 marksIntegrationModelling

15

The questions in this section refer to the article on the Insert. You should read the article before attempting the questions.

The relevant parts of the article “Modelling a tube” are reproduced below; the line numbers are those printed on the Insert.

Lines 1–5
Products such as toothpaste and hand cream are often sold in tubes which have a circular cross-section at the end which has the opening for the product to be dispensed. The other end of the tube is closed and is a straight line. … The circular end will be defined to be the bottom end of the tube and the straight line end will be defined to be the top end.

Lines 25–27
The cross-section at the bottom of the tube is a circle, as shown in Fig. C3.1; at the top of the tube, the cross-section is a line, as shown in Fig. C3.3.

Fig. C3.3: a straight line of length pi r
Fig. C3.3

Lines 41–42
Taking the limit as \(\delta y \to 0\) and evaluating the resulting integral gives \(V = \frac{2}{3}\pi r^2 h\). This is less than the volume of the cylinder, \(\pi r^2 h\), as expected.

A typical tube of toothpaste measures 5.4 cm across the straight edge at the top and is 12 cm high. It contains 75 ml of toothpaste so it needs to have an internal volume of 75 cm3.

Comment on the accuracy of the formula \(V = \frac{2}{3}\pi r^2 h\), as given in line 41, for the volume in this case. [3]