June 2025 Paper 1 Q12
12 A student dissolves 0.5 kg of salt in a bucket of water. Water leaks out of a hole in the bucket so the student lets fresh water flow in so that the bucket stays full.
They assume that the salty water remaining in the bucket mixes with the fresh water that flows in, so the concentration of salt is uniform throughout the bucket.
They model the mass \(M\) kg of salt remaining after \(t\) minutes by \(M = ak^t\) where \(a\) and \(k\) are constants.
The student measures the concentration of salt in the bucket at certain times to estimate the mass of the salt remaining. The results are shown in the table below.
| \(t\) minutes | 8 | 13 | 21 | 35 | 50 |
|---|---|---|---|---|---|
| \(M\) kg | 0.4 | 0.3 | 0.2 | 0.1 | 0.05 |
The student uses this data and plots \(y = \log_{10} M\) against \(x = t\) using graph drawing software. The software gives \(y = -0.0214x - 0.2403\) for the equation of the line of best fit.
Comment on the accuracy when the model is used to estimate the initial mass of the salt. [2]
| Scheme | Marks | AO |
|---|---|---|
| \(\log M = \log(ak^t)\) | ||
| \(\log M = \log k^t + \log a\) | ||
| \(\log M = t\log k + \log a\) | B1 | 2.1 |
| [1] |
Notes
\(\log M = \log k^t + \log a\): this line of working must be seen as well as the given result
B1: AG
| Scheme | Marks | AO |
|---|---|---|
| (i) Intercept \(\log a = -0.2403\) | M1 | 3.1a |
| \(a = 10^{-0.2403} = 0.575\) | A1 | 3.3 |
| Gradient \(\log k = -0.0214\) \(k = 10^{-0.0214} = 0.9519\) | A1 | 3.3 |
| [3] | ||
| (ii) This means that every minute, the mass of salt is reduced to 95% of its mass at the start of the minute | B1 | 3.3 |
| [1] |
Notes
(i) M1: Equates \(\log a\) to the intercept of the given line or equates \(\log k\) to the gradient of the given line
(i) A1: Accept awrt 0.57 or 0.58 Accept one answer in index form
(i) A1: Accept awrt 0.95. Second value must be evaluated
(ii) B1: Also accept that the mass is reduced by 4.8% or 5% per minute FT their value
Accept without a value for “the proportion of the mass of salt preserved each minute” oe
| Scheme | Marks | AO |
|---|---|---|
| When \(t = 0,\ M\,[= a] = 0.575\) | M1 | 3.4 |
| Which is quite close to the given value 0.5 kg | A1 | 3.5a |
| [2] |
Notes
M1: Uses \(t = 0\) and their positive value of \(a\).
Also allow for \(\log 0.5 = -0.3010\)
A1: Compares their \(M\) with 0.5 kg or their \(\log 0.5\) with \(-0.2403\) (must be seen)
Small percentage error so reasonable model. Allow for not very good fit
| Scheme | Marks | AO |
|---|---|---|
| \(\log 0.01 = -0.0214t - 0.2403\) | M1 | 3.4 |
| \(t = 82.2\) | A1 | 3.4 |
| [2] |
Notes
M1: Uses \(\log 0.01\) in the given equation soi
A1: Allow value between \(82 \leqslant t \leqslant 83\)
Alternative method
| Scheme | Marks | AO |
|---|---|---|
| When \(0.01 = ak^t\) | M1 | |
| \(t = 82.2\) | A1 |
M1: Uses their values of \(a\) and \(k\) to form an equation for \(t\) and attempt to solve. May be implied by a value for \(t\) seen
A1: To allow for values of \(a\) and \(k\) rounded to 2 sf, allow value \(78 \leqslant t \leqslant 83\)
| Scheme | Marks | AO |
|---|---|---|
| \(M = a\mathrm{e}^{-ht} = ak^t\) So \(\mathrm{e}^{-h} = k\) | M1 | 3.1a |
| \(h = -\ln k = 0.0493\) \(M = 0.575\mathrm{e}^{-0.0493t}\) | A1FT | 1.1 |
| [2] |
Notes
M1: Equates expressions for \(M\) soi FT their \(k\) and \(a\)
A1FT: FT their \(a\) only. Allow \(0.049 \lt h \lt 0.052\)
Allow \(M = 0.575\mathrm{e}^{t\ln 0.952}\) (corrected from the printed mark scheme: it prints \(M = 0.575\,e^{-\ln 0.952t}\), which has the wrong sign, since \(h = -\ln 0.952\))
Alternative method: uses given value for initial mass
| Scheme | Marks | AO |
|---|---|---|
| Uses given value for initial mass \(M = 0.01 = 0.5\mathrm{e}^{-ht} = 0.5\mathrm{e}^{-82h}\) | M1 | |
| \(h = 0.0477\) so \(M = 0.5\mathrm{e}^{-0.0477t}\) | A1 |
M1: Allow the use of one of the data points from the table for M1 only
A1: Allow \(0.0471 \lt h \lt 0.0502\)
Alternative method: uses their \(a\) as initial mass
| Scheme | Marks | AO |
|---|---|---|
| Uses their \(a\) as initial mass \(M = 0.575\mathrm{e}^{-ht}\) \(0.01 = 0.575\mathrm{e}^{-82h}\) | M1 | |
| \(h = 0.0494\) so \(M = 0.575\mathrm{e}^{-0.0494t}\) | A1 |
M1: Allow the use of one of the data points from the table for M1 only
Allow their value of \(a\)
A1: Allow \(0.0488 \lt h \lt 0.0519\)
| Scheme | Marks | AO |
|---|---|---|
| Rate of decrease is \(ha\mathrm{e}^{-ht}\) | M1 | 1.2 |
| At \(t = 10\) rate of decrease is \(0.0493 \times 0.575\mathrm{e}^{-0.0493 \times 10} = 0.0173\ldots\) [kg per minute] | A1 | 3.1a |
| [2] |
Notes
M1: Soi Allow sign error. FT their \(h\) (Q. asks for rate of decrease)
A1: Accept values between 0.017 and 0.018